EasyManua.ls Logo

Jonsered ST 2368 EP - User Manual

Jonsered ST 2368 EP
24 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Always Wear Eye Protection During Operation
Gasoline containing up to 10% ethanol (E10) is acceptable for use in this machine.
The use of any gasoline exceeding 10% ethanol (E10) will void the product warranty.
ST 2368 EP
Operator's Manual
115 73 45-27 Rev. 3
WARNING:
Read this Man u al and follow all Warnings
and Safety Instructions. Fail ure to do so
can re sult in serious in ju ry.

Table of Contents

Questions and Answers

  • S
    sotoannAug 11, 2025
    Why is my Jonsered Snow Blower losing power?
    • T
      Tracy FranklinAug 12, 2025
      A loss of power in your Jonsered Snow Blower could stem from several issues: * A loose spark plug wire. Reconnect the spark plug wire securely. * Throwing too much snow. Reduce the speed and width of your snow removal path. * The fuel tank cap is covered with ice or snow. Clear any ice and snow from around the fuel tank cap. * A dirty or clogged muffler. Clean or replace the muffler to ensure proper exhaust flow.
  • D
    David GarzaAug 17, 2025
    What to do if my Jonsered ST 2368 EP engine idles or runs roughly?
    • M
      Maria MaloneAug 17, 2025
      If your Jonsered Snow Blower engine is idling or running roughly, here are a few things to check: * Ensure the choke is not in the FULL position; move it to the OFF position. * Check for a blockage in the fuel line and clean it if necessary. * Old or stale fuel can cause issues; empty the fuel tank and carburetor, then refill with fresh, clean gasoline. * Water in the fuel can also lead to rough running; empty the fuel tank and carburetor, then refill with fresh, clean gasoline. * The carburetor may need adjustment or an overhaul. In this case, it's best to contact an authorized service center/department.
  • M
    marklinAug 23, 2025
    Why is my Jonsered ST 2368 EP losing snow discharge?
    • J
      John PenaAug 25, 2025
      If your Jonsered Snow Blower experiences a loss or slowing of snow discharge, consider the following: * The auger belt may be off the pulley. Check and reinstall the auger belt if needed. * The auger belt could be worn. Inspect and replace the auger belt if necessary. * The discharge chute may be clogged. Clean the snow chute to ensure proper discharge. * The augers or impeller might be jammed. Remove any debris or foreign objects from the augers and impeller.
  • R
    Randall FloresAug 29, 2025
    Why is my Jonsered ST 2368 EP losing traction?
    • P
      Paula DawsonAug 29, 2025
      If you're experiencing a loss of traction or slowing of drive speed with your Jonsered Snow Blower, here's what to investigate: * A worn drive belt. Check and replace the drive belt if it's worn. * The drive belt may be off the pulley. Check and reinstall the drive belt. * A worn friction drive wheel. Contact an authorized service center/department.
  • K
    Kathy PerrySep 4, 2025
    Why is my Jonsered ST 2368 EP Snow Blower vibrating so much?
    • S
      Susan BaileySep 4, 2025
      Excessive vibration in your Jonsered Snow Blower can be attributed to loose parts or damaged augers or the impeller. Tighten all fasteners and replace any damaged parts. If the vibration persists, it's recommended to contact an authorized service center/department.

Jonsered ST 2368 EP Specifications

General IconGeneral
TypeTwo-stage
Engine manufacturerBriggs & Stratton
Number of forward gears6
Electric starterYes
Auger materialSteel
Clearing width68 cm
Throw distance15 m
Starter typeElectric

Related product manuals