Remove all packaging materials before operation.
1. Observing the correct polarity, install 2 D-cell batteries
into the battery box and close the lid.
2. Connect the ‘blue’ and ‘red’ Joolca quick connect fittings
to the ‘Water Input’ and ‘Water Output’ threads
respectively.
3. To connect the showerhead to the shower hose, place
one of the washers (contained in the pack) into one end
of the threaded fitting of the hose. Apply Teflon tape to
avoid leaks and attach the nozzle.
4. Attach the shower hose to the ‘red’ quick connect fitting
(water output).
5. Go over and tighten all hose fittings and connections to
ensure water tightness.
!
!
!
!
!
!
To Next Page
Loading...