1. Ensure that the flow regulation switch on the shower
nozzle handle is in the ‘Off’ position.
2. IMPORTANT! It is important that when starting the
appliance that the gas regulator is set to the ‘minimum’
position (i.e. turned completely to the left).
3. IMPORTANT! It is important that when starting the
appliance that the water regulator is set to the ‘maximum’
position (i.e. turned completely to the left).
!
4. Turn the gas cylinder on, ‘Open’, in an anticlockwise
direction one full turn.
5. Open the valve for the input water source.
Note: Water should not flow out as the shower nozzle is
in the ‘Off’ position.
6. When ready, slide the flow regulation switch on the
shower nozzle to the ‘On’ position. Water will start to flow.
7. Adjust the temperature and flow rate through the
shower head by adjusting the ‘Flame’ and ‘Water Flow’
knobs.
!
Note: For higher temperatures increase the ‘Flame’ regulator
control and decrease the ‘Water Flow’ regulator control.
Warning! Take care to test the temperature of the water flowing
from the shower head as it may be hot enough to cause injury.
The water flow can be stopped at any time by sliding the
regulation switch on the shower head to the ‘Off’ position. The
burner will extinguish.
To reignite the burner, slide the flow regulation switch on the
shower head to the ‘On’ position. Water flow will commence and
the burner will once again ignite.
To Next Page
Loading...