EasyManua.ls Logo

Joovy Caboose UL - Stroller Assembly; Unpacking the Product; Unfolding the Stroller; Installing Rear Wheels

Joovy Caboose UL
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6
Stroller Assembly
IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
Unpacking the Product
Remove everything from the box – stroller, canopy, two rear wheels, two front wheel sets, tray,
parent organizer, infant car seat adapter and documents (not shown).
Discard all packaging materials properly including plastic coverings.
DO NOT allow children to play with any packaging materials.
IWARNING: Adult assembly is required for this product. No
tools required.
Unfolding
Keep children away from stroller while unfolding.
Release the folding lock located on the right side by lifting the lever o of the catch. (1)
Lift up on the handlebar of the stroller until the frame snaps into its open locked position.
CAUTION: While unfolding the stroller, be careful to keep your ngers from being pinched by
moving parts.
NOTE: Remove packing foam from rear frame assembly to ensure stroller locks in the open
position.
Lock the safety latch. (2)
Ensure that the safety latch is secured before ANY use of the stroller.
IWARNING: ALWAYS secure the safety latch on the side
of the stroller when it is in the unfolded use position. This will prevent
collapse of the stroller should the handlebar trigger locks be accidentally
opened. Possible pinching hazard - Be careful when unfolding the stroller.
Installing/Removing Rear Wheels
Install one rear wheel by sliding it onto the axle until it clicks into place. (3)
Repeat for other rear wheel.
Pull on the wheels to ensure they are installed securely.
• To remove each wheel, push up the plastic tab on the rear axle and then pull the wheel outward
from the stroller. (4)
Installing/Removing the Front Wheels
Place the front wheel sets onto the front wheel posts until they click in place. (5)
Pull on the wheel sets to ensure they are installed securely.
• To remove each wheel, press down on the plastic tab in the hole at the bottom of the front wheel
and then pull the wheel outward from the stroller. (6)
Front Wheel Locks
The front wheels can be set to swivel or lock.
• To lock the front wheels, rotate each wheel set so that it points forward.
Pull up on the locking lever to engage the swivel lock. (7)
To unlock the wheels (swivel mode) push down on the lever.
Installing and Operating the Canopy
Position the canopy with the sun visor forward.

Related product manuals