6
Stroller Assembly
IMPORTANT NOTE: Please refer to the end of this manual for all photos
that are referenced in parentheses in the instructions below.
IWARNING: Adult assembly is required for this product. No
tools required.
Unfolding the Stroller
• Orient the stroller with the handle facing upward. Release the safety latch located on the left side
of the stroller. (1)
• Pull upwards on the handle. (2) Keep pulling until the stroller is fully erected and the folding hinge
on each side engages.
• Visually check and gently push downward on the handle to ensure that the stroller is completely
opened and locked before ANY use of the product.
IWARNING: Keep children away from stroller while
unfolding. ALWAYS ensure the folding mechanism on each side of the
handlebar is fully engaged when the stroller is in the opened position. This
action will prevent collapse of the stroller. Possible pinching hazard – Be
careful when unfolding the stroller.
Installing/Removing the Front Wheels
• Slide one front wheel into the front wheel housing until it clicks into place. (3) Repeat for the other
two wheels. Pull on the wheels to ensure they are installed properly.
• To remove, press the metal release button on the back of the front wheel housing and pull away
from the stroller. (4)
Installing/Removing the Rear Wheels
• Install a rear wheel by sliding the axle into the hole in the wheel hub until it clicks into place. (5)
Repeat for the other wheel. Pull on the wheels to ensure they are installed properly.
• To remove, push the release button on the rear wheel hub and pull the wheels from the stroller. (6)
Installing/Removing the Tray
• Remove the two safety caps from the seat mount points by pressing the release button and pulling
each cap o. Store the safety caps in a safe place for future use. (7)
• To attach each tray, orient it with the male ttings pointed towards the seat. (8) Insert the male
ttings on the tray into the female ttings located on both sides of the seat until they snap into
place. Pull outward on the tray to ensure it is secure.
• To remove, press the buttons located on the underside of both female ttings inward and pull the
tray away from the seat. (9)
• When using the stroller without the tray, always replace the safety caps.
IWARNING: For use ONLY on the Joovy Kooper RS2
Stroller. The tray is not a restraint device. ALWAYS secure your child
with the restraint system. NEVER lift the stroller by the tray. Use caution
when attaching the tray when there is a child seated in the stroller. The
maximum weight that can be carried in each tray is 2 lbs. (0.9 kg).
To Next Page
Loading...
Need help?
General
