Introduction:
Congratulations
on your purchase of a
Varga VA 10 Circular
Saw! It is state of the art
for precision material
cutting, and has
applications in many
different industries,
including Sign Making,
Engraving, Industrial
Panel Production, Trophy
& Awards, Advertising
Specialty, and a variety of
other applications
requiring sizing of plastic,
non-ferrous metal, and
other sheet material (not for use on steel, or magnetic material). The Varga VA 10 requires very
little assembly, is pre-aligned, and is extremely easy to use. The safety features incorporated in
this equipment make it one of the most “worry free” machines on the market, and while it is very
important to follow all standard safety procedures during operation, it was truly designed with
safety in mind. You will find this product to be extremely accurate, and of high quality
construction, which will provide a long service life, if properly maintained. Your new Varga VA
10 is warranted for one year from date of sale against defects in manufacturing, parts or
workmanship. Your distributor welcomes your comments or suggestions.
Assembly:
1. Remove the main body of the saw from the cardboard container, and locate the small box
or boxes containing the saw accessories.
2. The accessory box will include a chip collection
bag, chip collector mounting bracket, mounting screw, and
chip collector bag spring clip for holding the bag in place.
Install the chip collector, mounting bracket on the bottom
of the saw base using the screw included. The mounting
hole is on the bottom left, front side of the base as shown
in the picture on the front of this manual (#2). The
cylindrical part of the bracket should be in the up position.
3. Insert the top opening of the blue chip collector bag up through the center of the
mounting bracket, fold the cloth down over the cylindrical part of the bracket, and secure it by
bringing the spring clip down over the cloth and cylindrical part of the bracket. Insert the plastic
Distributed & Supported by:
Jorlink USA, Inc. | Tel: (336) 288-1613
support@jorlink.com | www.JORLINK.com
To Next Page
Loading...