Why does the cooler fuse trip when turning on the JOSAM JH1500 Electric Heater?
If the cooler fuse trips when turning on the JOSAM Electric Heater, it indicates a problem within the cooler section. Check for a faulty phase switcher, water pump, fan, and compressor.
Why does the main fuse trip when turning on the JOSAM JH1500 Electric Heater?
If the main fuse trips when turning on the JOSAM Electric Heater, it indicates a problem in the electrical section of the machine. Check for a faulty rectifier, power module, or hose packet.
What to do if there is a water leak between the inductor handle and the inductor head of the JOSAM JH1500?
If you notice a water leak between the inductor handle and the inductor head of your JOSAM Electric Heater, it's likely due to damaged O-rings or loose screws. Replace the O-rings or tighten the screws to resolve the leak.
General| Brand | JOSAM |
|---|---|
| Model | JH1500 |
| Category | Electric Heater |
| Language | English |
Lists specific warnings like unstable surfaces, electrical modifications, loose cables, and flammable materials.
Warns against wearing metal objects due to magnetic field heating and burn injuries.
Highlights that servicing requires qualified personnel and unplugging the device.
Explains cooling systems, residual current breaker, automatic fuses, and inductor handle insulation.
Details electrical connection requirements, including voltage versions and fuse protection.
Describes the On/Off button, power adjustment, and power indicator LEDs on the control panel.
Details the red LEDs for overheating and water flow, and the general electronic alarm.
Details the steps for heating an object and related safety warnings.
Reiterates warnings about qualified electricians, unplugging the device, and avoiding metal objects.
Lists common faults like no current or no operation and their solutions.
Covers faults related to water leaks and overheating, with corresponding actions.
Addresses problems with water flow indicators and their resolutions.
Explains issues indicated by simultaneous blinking of red LEDs (phase fault, sensor fault).
Addresses blinking LEDs at start-up related to overheating or water flow sensors.
Covers issues with the operation LED and the handle getting hot during heating.
Details causes for RCB, cooler fuse, and main fuse trips.
To Next Page