4.0 Service
Warning! Any unauthorised change to the product is illegal.
Only use original spare parts.
4.1 Replacing the baffle/exhaust
deflector (fig. 20 and 23)
(N.B. If you use tools, be aware that the vermiculite plates may
be damaged by rough treatment).
Lift up the front edge of the baffle plate and tilt it out 1. (fig. 23G).
Remove the side burn plates (fig. 23F) and the rear burn plate
(fig. 23 E).
The exhaust deflector, in cast-iron - that is located above the 2.
baffle plate, rests with the bar on the ribs at the rear flue
outlet (fig. 20A). Lift the exhaust deflector slightly up, pull it
forward and tilt it out.
For reassembly follow the same procedure for installation, 3.
but in reverse.
4.2 Replacement of burn plates/base
plate (fig. 21 and 23)
(N.B. If you use tools, be aware that the vermiculite plates may
be damaged by rough treatment).
Lift up the front edge of the baffle plate and tilt it out. 1.
Remove the side burn plates (fig. 23F) and the rear burn plate
(fig. 23 E).
Then lift up the grate and the base plate and take it out 2. (fig. 23 D).
Follow the same procedure for installation, but in the opposite 3.
sequence.
When reassembling the grate and the base plate, make sure 4.
that the riddling bar (fig. 21 A) that moves the riddling grate
is threaded into the slot on the right edge of the grate.
4.3 Replacing the inner/outer side
glass (fig. 23, 24 and 25)
Lift up the front edge of the baffle plate and tilt it out Remove 1.
the side burn plates (fig. 23F) and the rear burn plate (fig. 23E).
The exhaust deflector, in cast-iron - that is located above the 2.
baffle plate, rests with the bar on the ribs at the rear flue
outlet (fig. 20 A). Lift the exhaust deflector slightly up, pull it
forward and tilt it out.
Remove riddling grate, base plate and ash pan. 3.
Unscrew the upper and lower screws 4. (fig. 24 A and 25 A), and
tilt the glass holder with the glass carefully out through
the door. N.B. The glass holder also keeps the outer glass
in place
Remove the glass and possibly replace gaskets. If needed 5.
replace the external glass.
For reassembly follow the same procedure for installation, 6.
but in reverse.
eNglish
5.0 Optional equipment
5.1 Decoration plates
Decoration plates, fairy tale (2 units), black paint
- cat. no. 350986
Decoration plates, fairy tale (2 units), grey paint
- cat. no. 350987
Decoration plates, reed (2 units), black paint
- cat. no. 350988
Decoration plates, reed (2 units), grey paint
- cat. no. 350989
Decoration plates, cover for side windows (2 units), black paint
- cat. no. 350990.
Decoration plates, cover for side windows (2 units), grey paint
- cat. no. 350991.
Soap stone, top - cat. no. 350992
5.2 Glass decoration, top, sides and front
(see separate installation manual)
Glass set for rear smoke outlet, black paint,
- cat. no. 350993
Glass set for rear smoke outlet, grey paint,
- cat. no. 350994
Glass set for top smoke outlet, black paint,
- cat. no. 350995
Glass set for top smoke outlet, grey paint,
- cat. no. 350996
5.3 Rotating set
(See separate installation manual)
Rotating set for Jøtul F 373, - cat. no. 350997
5.4 Wood store
Black paint - cat. no. 351160
Grey paint - cat. no. 351161
To Next Page
Loading...
