7.0 Servicing
Warning! Any unauthorised change to the product is illegal. Only
use original spare parts!
7.1 Replacement of baffle plate – fire
grate and base plate – burn plates
• Thebaffleplate(Fig. 15), which lies on the burn plates, should
be lifted and tilted down and out of the door.
• Removetheburnplatesasdescribedundertheinstallation
of the stove (fig. 8 - 14)
• Lift thefiregrateandbaseplate(fig. 3) up and tilt them
out.
Follow the same procedure for installation, but in the opposite
sequence.
8.0 Optional equipment
Guillotine solution
The guillotine solution is delivered completely mounted in a
package
Assembly instructions are included.
Installation of ash holder (fig. 19 - 20)
1 Attach the included gasket under the edge of the outer
container (se fig. 19A).
2 Lower the outer container down through the bottom of the
fire chamber (20B). and secure using 4 plate screws from the
inside.
3. Place the ash bin in the outer container
9.0 Reasons for operational
problems - troubleshooting
Poor draught
• Checkthelengthofthechimneyandthatitcomplieswith
national laws and regulations. Make sure that the minimum
cross section on the chimney is large enough. See also «2.0
Technical data» and «4.5 Chimney» for information.
• Makesurethatthereisnotanythingpreventingthesmoke
gasses from escaping: Branches, trees, etc.
The fire extinguishes after a while
• Makesurethatthefirewoodissufficientlydry
• Findoutwhetherthereisnegativepressureinthehouse,close
mechanical fans and open a window close to the stove.
• Checkthattheairventisopen.
• Checkthattheflueoutletisnotcloggedbysoot
Unusual amount of soot accumulates on the
glass
Some soot will always stick to the glass, but the quantity depends
on:
• Humidityofthefuel.
• Thelocaldraughtconditions
• Regulatingtheairvent.
Most of the soot will normally burn off when the air vent is
opened all the way and a fire is burning briskly in the fireplace.«6.1
Cleaning the glass - good advice» .
eNglish