JourneyMan HD-9140 - User Manual

Questions and Answers

X
xgardnerAug 1, 2025
Why do my JourneyMan HD-9140 lights stay on continuously?
- J
  Jeffrey SmithAug 1, 2025
  Your JourneyMan Accessories lights might stay on continuously because a lamp is positioned too close to the sensor or pointed at objects that cause the sensor to trigger. Try aiming the lamp away from the sensor or those objects. Alternatively, the control might be pointed at a heat source like an air vent, dryer vent, or brightly-painted heat-reflective surface. In this case, re-aim the sensor and turn Boost off.
J
Jessica GomezAug 6, 2025
What to do if my JourneyMan HD-9140 lights come on for no apparent reason?
- J
  jody16Aug 6, 2025
  If your JourneyMan Accessories lights are activating unexpectedly, it could be that the control is sensing small animals or automobile traffic. Try re-aiming the sensor or using a lens shield. Another possibility is that the sensitivity is set too high. In this case, reduce the sensitivity and turn Range Boost off.
K
karnoldAug 13, 2025
How to fix JourneyMan Accessories lights that will not come on?
- H
  heidi17Aug 13, 2025
  If your JourneyMan Accessories lights are not turning on, there are several potential causes: 1. The light switch might be turned off, so check if it is on. 2. The flood light could be loose or burned out; tighten or replace it. 3. A fuse might be blown, or a circuit breaker could be turned off; inspect the fuse or circuit breaker. 4. The daylight turnoff feature may be active; re-check after dark. 5. If it's a new installation, there might be incorrect circuit wiring; check the circuit wiring. 6. The sensor might need adjustment; adjust the sensor aim to cover the desired area.
J
Jeffery KaiserAug 19, 2025
What to do if my JourneyMan HD-9140 Accessories lights flash on and off?
- C
  Christina BarnesAug 19, 2025
  If your JourneyMan Accessories lights are flashing on and off, it could be due to several reasons: * Heat or light from the lamps may be turning the Light Control on and off. Aim the lamps away from the sensor and turn Boost off. * Reflected heat from other objects might be triggering the sensor. Re-aim the sensor and turn Boost off. * The control might be in the process of warming up. Wait 1 minute for the sensor to warm up. * The control may be set to Test mode. Set the control switch to an ON-TIME position.
R
Rhonda RobertsAug 25, 2025
Why do my JourneyMan HD-9140 lights come on in daylight?
- K
  kturnerAug 26, 2025
  If your JourneyMan Accessories lights are activating during the day, it could be because the control is installed in a relatively dark location. Relocate the control to a brighter area. Alternatively, the control might be in Test mode. Set the control switch to an ON-TIME position.