RAMPS 1.4 KIT
Ramps 1.4 with display & 5x A4988 motor driver
1. GENERAL INFORMATION
Dear customer,
thank you for choosing our product. In the following, we will show you how
to use your product.
Should you encounter any unexpected problems during use, please do not
hesitate to contact us.
With this set you lay the foundation for the installation of your own 3D
printer on the basis of Arduino.
Not only the required stepper motor output stages are included, but
also the board oers connections for up to 3 heating units (printing bed
heating, extruder 1, extruder 2) with each 3 possible inputs for connecting
the required temperature sensors. In addition, fans for component and
extruder cooling can also be connected.
With the tting installed soware on the Arduino Mega, it can show you the
current status or rather information like temperature on the included
LCD-display.
To Next Page
General