Post "E" onto Plate " 11 "
with Screw "b" .
Plate " 11 " onto Scratching
Post "B" and Post "D" with one Screw "b"
and one Screw "f".
Perch " 5 " onto
Scratching Post "C" .
CAT TREE USER MANUAL
Post "B" and
two Scratching Post "D" to the Base Plate
" 1 " with four Screws "f".
48x48cm*1
1
35cm*2
35cm*2
D
B
M8x40*4
f
Plate " 3-1 "
onto one Scratching Post "B" and one
Scratching Post "D" with two Screws "b".
48x20cm*1
M8x80*2
b
Step 3: On the right, install the Plate " 3-2 "
onto another Scratching Post "B" and another
Scratching Post "D" with two Screws "b",
as shown.
MORE SPECIFIC INSTALLATION STEPS
----- 3 -----
Step 4: As shown, use one Part " 8 ", one
Part " 9 ", two Post "F" and four Screws "f"
to install the ladder.
7x42cm*1
8
7x42cm*1
9
15cm*2FM8x40*4
f
Plate " 3-2 "
(which has 4 screw holes) with two
Screws "a".
M8x20*2a
Step6: Hang the hammock Part " 4 "and Part
" 7 " on the Plates (" 3-1 " , " 3-2 ") on
Step7: Fix two Scratching Post "B" and two
Scratching Post "D"
as shown.
35cm*2
35cm*2
D
B
48x20cm*1
M8x80*2b
Step8: Connect the Hanging Rope " 12 " to
Plate " 2 ".
48x48cm*1
2
2 + 12
35cm*1
12
Plate "②"+ the Hanging Rope
" 12 " onto to the Posts with two Screw "f"
and two Screws "b".
Cover " 6 ", four Post "A", and eight
Screw "f".
Post "B" and
one Post "D"Plate "②".
Step 12: Place the Condo onto Plate " 2 ". Fix
it with one Screw "a" from the Center of
35cm*1
35cm*1
D
B
35x30x25cm*1
6
22cm*4M8x40*8 A
f
Post "C" onto
the Condo with one Screw "f".
M8x80*2
M8x40*2
b
C
f
48x20*1
11
M8x80*1b M8x40*1
35cm*1
M8x40*1
f
10
f
φ30x5cm*1
5
Balls
"⑩"into the hole of the Post "E".
hole when it is �lted 45°
Completeled, Just Enjoy it!
35cm*1
E
*3
M8x20*1
a
45°
40x40cm*1
4
40cm*2
7
To Previous Page
Loading...
Need help?
General