Joysway MAGIC VEE V5 - Transmitter and Battery Setup; Installing the 9 V Dry Battery; Charging the 6.4 V Power Pack

2
Always use a fresh 9V battery in the
transmitter.
1) Ensure transmitter ‘ON/OFF’ switch is in the
‘OFF’ position.
2) Remove battery cover screw.
3) Remove battery cover by pressing down on
the embossed arrow and sliding the cover as
indicated.
4) Insert 9V battery, noting correct location
(polarity + or -).
5) Slide battery cover back into place.
6) Re-fit battery cover screw.
NOTE 1: The Magic Series are supplied with a
start-up 9V dry cell battery. Once this battery
is depleted, please replace it with another dry
cell 9V battery (alkaline recommended) or fully
charged 9V rechargeable battery. Remove 9V
battery from the transmitter if you do not intend
to use it for a period of time.
NOTE 2: When the transmitter battery (dry cell
or rechargeable) is at the end of its life, it should
be disposed of at an app
roved battery recycling
centre.
CHARGING THE 6.4V POWER PACK
2 6
9V Battery
4
3
5
1‘OFF’
Magic Vee V5/Cat V5 RTR Micro EP Speed Boat
DO NOT DISPOSE OF IT IN HOUSEHOLD
WASTE!
INSTALLINGTHE 9V DRY BATTERY IN YOURTRANSMITTER
1) Insert the USB charger into a USB port, or use
the included 12V car adapter if you want to
charge in the field.
2
) Plug in the 6.4V LiFePo battery to the charger
cable. An LED light will begin to blink in the
base of the USB plug to indicate that the
battery is charging.
3
) A fully discharged battery will take about
80min to fully charge. Do not overcharge.
Do not leave the battery unattended while charging.
4
) The blinking LED light will turn solid when the charge is complete. Disconnect the 6.4V LiFePo battery
from the charger.
• The 6.4V LiFePo battery does not come pre-charged.
You must fully charge the battery before using the boat
• The 6.4V LiFePo battery can be re-charged many times before it needs to be replaced.
When the battery no longer holds a charge (is dead), it should be properly recycled.
NOTE 1: The boat will typically run for about 8 min on a fully charged battery. As soon as you notice a
drop off in speed, you should bring the model back to shore or you may lose control of the boat.
NOTE 2: Continuous running of the model will generate high heat levels, which will lead to premature
wear on the motor. It is recommended to let the model cool down for about 5-10 min before
installing a re-charged battery pack.