The binding process effectively ties the transmitter and receiver together. Under normal circumstances, both
items are supplied like this from the factory. If, however, you find that your transmitter and receiver are not
bound(receiver’s red LED is on), you should do the following:
1) Switch “ON” the transmitter.
2) Switch “ON” the receiver by Attaching 6.4V power pack’s connector to the matching connector in the
Magic Series boat.
3) Press down the “BIND” button on the receiver, the receiver’s green LED will be on to indicate that binding has
been successful and the receiver will now accept commands from the transmitter.
Note 1: During binding process, transmitter and receiver should be no more than one meter apart and no other
similar devices should be within 10 meters.
Note 2: if the green light flashing, showing the binding failure, please do again as above indication.
TRANSMITTER/RECEIVER BINDING
Insert the 6.4V Power Pack into the left side of
the hull.
3
(Model should be placed on its supplied
boat stand)
1) Remove the Magic Series’s upper deck by
pulling carefully on the catch at its rear section.
2)
3)
4) Re-position the upper deck.
Attach the 6.4V Power Pack’s connector to
the matching connector in the Magic Series. Do
not force them together - they only attach
one way!
2
3
1
4
HOW TO CONTROL/OPERATE YOUR MAGIC SERIES
1) Forward Throttle Trigger
Your Magic Series can be driven forward by
pulling the throttle trigger. Release the
trigger and the Series Vee will stop.
2) Left/Right Steering Wheel
The steering wheel controls the Magic Series’s
left and right movement. Turn the wheel to
the left to steer to the left. Turn the wheel
to the right to steer to the right. Release the
wheel to go straight.
Racing Tip: The Magic Series is an oval racer,
designed for clockwise racing, and will be less
responsive to steering inputs at high speed,
particularly left turns. Decrease your speed to
allow tighter turning.
1
2
Magic Vee V5/Cat V5 RTR Micro EP Speed Boat
NOTE: 1. There is a water proof rubber ring placed along the slot of hull, always make sure it’s secured
positioned before re-position the upper deck.
2. It is suggested that don’t leave the rubber ring in the slot of hull. Remove the rubber ring when
not racing the boat, so as to keep the rubber ring flexible for water proof effective.
INSTALLING THE 6.4 V POWER PACK IN THE MAGIC SERIES
To Next Page
Loading...
