JPS Communications NIR-10 - User Manual

39 pages

Save Page as PDF

To Next Page

Main Page

Contents3
Brief Description5
Noise Reduction Mode5
Notch Filter Mode5
Quick Operation6
Connect Power6
Bandpass Mode6
Bypass Mode6
Connect Audio Input7
Connect Speaker or Headphones7
Turn on Power7
Initial Settings, Radio Settings7
Connections8
Power Requirements8
NIR Mode8
Bandpass Mode Info8
Connection Diagram9
Vehicular Operation10
Audio Input10
Input Level Adjust11
Speaker Output11
Headphone Output12
Remote Bypass12
Controls & Indicators13
Power Switch13
Mode Switch13
Invert Remote Bypass13
BW Switch14
NIR Level/Bp Shift Control14
Peak Indicator14
Operation15
NIR/NF Mode on Voice15
Volume Control15
NIR Mode on CW16
NIR Mode on RTTY, SSTV, Packet, Etc.16
Bandpass Mode Overview17
Bandpass Mode on Voice17
Operational Limitations18
Transmit Audio Processing19
Technical Information20
Specifications20
Troubleshooting22
Remote Bypass Connections23
Connect to Your Transceiver's Remote Connector23
If the Signal Is Already in Use24
If Your Transceiver Has no Remote Connector24
Using the Remote Bypass Input24
Do NOT Connect to the Antenna24
Audio Section Technical Description25
Audio Input, Audio Output25
Audio Section: Miscellaneous25
DSP Section Technical Description26
DSP and AIC26
Power Supply26
Reset Generator27
Memory27
Software27
Peak Detector28
NIR-10 Audio/Power Supply Section Schematic29
NIR-10 DSP Section Schematic30
Connections to Transmit Audio Processing31
NIR-10 Addendum for Rev. 3.0 Software32
Nir-10 - Softare Update Rev. 3.036
Peak Mode36
Installation Instructions37
NIR-10 - Software Revision 4.038
NIR-10 - Installation Instructions39

Need help?

Do you have a question about the JPS Communications NIR-10 and is the answer not in the manual?

JPS Communications NIR-10 Specifications

General

Brand	JPS Communications
Model	NIR-10
Category	Sound Card
Language	English

JPS Communications NIR-10 - User Manual

Table of Contents

JPS Communications NIR-10 Specifications