JR ProPo 11BPX - User Manual

・HybridsystemwithPWM(11)andXBUS(3)
outputportsusingDMSS2.4GHztechnology.
・DualBatterySystem
・Two(DMSS)RA03TLSubReceiversincluded
・Powerswitchincluded(Etype)
・Ahighlyefficientsystemthatmonitorsvoltage
andmanagesthepowersupplybetweenbatt-
eriesinabalancedmannertopreventbiasesin
powerconsumption.
・EasyBindSystem
■11BPX■SwitchHarnessE■RA03TL(2)
■RGCable(2)■XT60ConnectorM(2)
■Accessories■InstructionManual
■Binding
!CAUTION!
Pluggingthebatteryintoaservoportwill
damagetheunit.Pleasebecareful.
WiththeESwitchintheOFFposition,con-
necttheRA03TLtothemainbattery.
Withthetransmitterto"Bindmode"turn
theESwitchtotheONposition.
WhentheLEDlightchangesfromflashing
tosteadylit,bindingiscomplete.
■XBUSServoIDSettings
Onthetransmitter'sXBUSorServosetting
mode,assignanIDtoeachservoindividually.
Dimensions:2.36x2.83x0.58inches
(60x72x14.5mm)
Weight:3.7oz/107g
OperatingVoltage:under12.6V
Modulation:DMSS2.4GHz
PWMPorts:11XBUSPorts:3
DANGER!!
Donotusethisproductintherainaswatermaycau-
seelectronicdevicestomalfunction.
Thisproductcarriesariskofinjuryduetoheat,fire
andelectricshock.
Neverdisassembleormodifythisproduct.
Donotusethisproductotherthantheoperating
voltagebetween6.0Vto12.6VBesuretocheckthe
polaritywhenyouinputthebatteryconnectorto
thisproduct.
Reverseconnectionmaydamagethisproductalmo-
stimmediately.
Besuretocheckthebatterycapacityuponoperating
thisproduct,ifthebatterycapacityisundertheope-
rationalvoltage,thisproductmaynotfunctionprop-
erly.
Pleasedonotinsertanyconductivematerialsuchas
screwdriverorsteelwiresintothisproductʼsopen
space.
Iftheproductdoesnotoperateproperly,Donotco-
ntinuetousetheproduct.Pleaseconsultwithour
service.
■
■
■
■
■
■
■
■
■
Notfollowingthisadvicecarrieshighriskofdeath
orseriousinjurytotheuserorthethirdparties.
Thankyouforpurchasingthisproduct.
Toallowcorrectandsafe
useofthisproduct,
pleasereadthisoperationmanual
OPERATIONMANUAL
11BPX
DMSS2.4GHz RECEIVER SYSTEM
with TELEMETORY & XBUS
SETTING
■−Ground
■＋Positive □Signal
■−Ground ■＋Positive
Besuretocheckthepolaritybefore actualinsertionoftheconnectors.
●−Ground
●＋Positive
ReceiverBattery2 suchasLi-Po3S
ReceiverBattery1 suchasLi-Po3S
●−Ground
□Signal
■−Ground
■＋Positive
●＋Positive
□Signal
OUTPUTPORTS
FORPWM SERVOS
SensorTerminal
Applicableto
connect
XBUSorPWM
Servo
E-SW
CONNECTION
DIAGRAM
※NeverConnect PWMServo
OUTPUTPORTS
FORXBUSPRODUCTS
Feature
Included
Specifications
OUTPUTPORTS
FORPWM SERVOS
Applicableto
connect
XBUSorPWM
Servo

Summary

Safety Warnings

Critical Safety Precautions

Essential safety advice including warnings about water, heat, voltage, reverse polarity, and modifications to prevent injury or damage.

Product Settings

Binding Procedure

Steps to bind the transmitter to the receiver for initial setup.

XBUS Servo ID Configuration

Guide to assigning unique IDs to XBUS servos for individual control.

JR ProPo 11BPX Specifications

General

Brand	JR ProPo
Model	11BPX
Category	Receiver
Language	English