JRC JLN-650 - Page 154

9-6
Warning No.
Warning Contents
Countermeasure Message
Display Control Unit
4-09
Setting data reading error
Please reboot after having switched it off once.
Does not “CF card 2” come off?
Please carry out the handling of the CF card after
switching it off.
4-10
Course plot data reading error.
4-11
Total distance run or trip data,
reading error.
4-12
Setting data writing error
4-13
Course plot data writing error.
4-14
Total distance run or trip data, writing
error.
4-15
―
(Non-display)
4-16
Non-display
（”Dummy data is not found” when
making it to a dummy mode.
）
Please reboot after having switched it off once. Does
not “CF card 2” come off?
Please carry out the handling of the CF card after
switching it off.
4-17
Non-display
（”Dummy data communication error”
when making it to dummy mode
）
4-18
An update file is not found.
4-19
Can't update it, for a communication
error.
Warning No
.
：
3-01
～
4-19
Remarks
Warning message;
１． It displays until erasing it by manually when
the warning message is appeared once.
２． The alarm sounds at the same time for about
30 seconds.
３． The message and the alarm sound
disappear with the [BUZZER] key.
４． The warning message is made non-display in
the menu setting. Please set a warning
usually to the display.
Menu/”Initial setting”/Installation setting
/Warning/Display ON
５． Example of Display: Refer to right figure.
Note: There is a warning without the warning number either. In that case, the warning number is
displayed by "***/ the warning code".
Inform the alarm code when inquiring.
Normality and abnormality can be confirmed about other items on the Self Test screen.
Warning
Date ：Year Month Day 14:40
Warning No. ：3-11
Situation ：
TX Protect.
Measure ：TX protection circuit operated.
Please check the TX output
voltage after power -switch on
again.
Display ：OFF the Warning indication
with “BUZZER” key.