JRC JMA-9823-9XA - Page 115

3 – 44
3
3.4 BASIC OPERATIONS
.
..
[
22
] Setting the Mode when the EBL2 Starting Point is Moved
1 Perform the operating procedures 1 and 2.
The EBL OFFSET ORIGIN Menu will appear.
“2.EBL2 L/L FIX” is in the initial mode and set in “OFF”.
When the EBL2 starting point is moved, the starting point of
EBL2 will remain at the set position on the radar display.
2 Press .
“2.EBL2 L/L FIX” will switch from “OFF” to “ON”.
When the EBL2 starting point is moved to a position, the
starting point of EBL2 will be fixed at the latitude and longitude
of that position.
3 Press .
The function will be reset to “OFF”.
1 Press .
The SETTING2 Menu will reappear.
2 Press .
The SETTING2 Menu will be closed.
Note: • The course data and the own ship’s latitude and longitude data are required to
activate this function.
• With this function ON, the starting point will be returned to the center if the
starting point of EBL1 is moved to outside the radar display.
0
0
Exit
2
2
SETTING2
EBL OFFSET ORIGIN
1.EBL1 L/L FIX
2.EBL2 L/L FIX
0.
EXIT
OFF ON
OFF ON