JRC JMA-9823-9XA - Display Mode Setting; Setting Bearing Display Mode; Setting Motion Display Mode

5 – 7
……Setting Motion Display Mode TM/RM …………………………
Press to select the true motion (TM) display mode or the relative motion
(RM) display mode. In the initial state, the mode is set to RM.
……Setting Bearing Display Mode AZI MODE ……………………
Press to set the bearing display mode.
AZI
MODE
TM
RM
5.2 DISPLAY MODE SETTING
● For further details of the TM/RM mode, refer to section 3.4 “Select True/Relative Motion
Display Mode”.
Note
● For further details of the AZI MODE, refer to section 3.4 “Select Bearing Display Mode”.
Note