JRC NWZ-4740 - Before Commencing the Operation; Symbols; Examples of the Symbols

NA11ZZ0920C
- 3 -
2. Running the Update Program
2.1. Switch the NWZ-4740 to the maintenance mode.
To switch to the maintenance mode:
1. Press to display the MAIN MENU.
2. Hold down and together until [0. EQUIP SET] is displayed.
2.2. Select [8. SOFT UPDATE] in the EQUIP SET menu.
Select DISPLAY for [1. UPDATE AREA].
Specify a desired transfer speed for [2. BIT RATE].
(The specified speed must be supported by the PC connected.)
Select [3. UPDATE STANDBY], and press . (The unit will enter the program transfer
standby mode.)
2.3. If any other applications are in use on the PC, shut them down, then run the update PC
program (NWZ4740 FLASH1.exe).
Screen at the start of the update PC program