JSP POWERCAP ACTIVE - Changing the Faceseal Skirt; Safety, Warnings, and Compliance; Safety Precautions; Warnings

SAFETY PRECAUTIONS:
• Powercap
®
Active
™
should only be used in situations where EN 12941:TH1 and EN 812 apply.
• Powercap
®
Active
™
does not provide protection against the effects of falling or thrown objects, or moving suspended loads.
• Powercap
®
Active
™
should not be used instead of an Industrial Safety Helmet as specied in EN 397.
• The instructions inside Powercap
®
Active
™
should be read and understood as well as these instructions before use.
WARNINGS!
• THIS APPARATUS MUST NOT BE WORN WITH THE BLOWER UNIT SWITCHED OFF.
• WHEN SWITCHED OFF A RAPID BUILD UP OF CARBON DIOXIDE AND DEPLETION OF OXYGEN MAY OCCUR.
• WHEN SWITCHED OFF NO RESPIRATORY PROTECTION IS PROVIDED.
• THE APPARATUS SHOULD NOT BE USED IN EXPLOSIVE OR OXYGEN DEFICIENT ATMOSPHERES
• AT HIGH WORK RATES THE PRESSURE IN THE DEVICE MAY BECOME NEGATIVE AT PEAK INHALATION FLOW.
• USING THE APPARATUS IN HIGH WIND VELOCITIES MAY AFFECT FILTERING EFFICIENCY.
Powercap
®
Active
™
is not designed for use in atmospheres that are immediately hazardous to user hygiene or health, have less than 19.5% oxygen content, contain gases or toxic
substances, or unknown compositions.
• DO NOT use Powercap
®
Active
™
in an explosive atmosphere.
• DO NOT expose Powercap
®
Active
™
to ames or sparks.
• DO NOT use Powercap
®
Active
™
in conned spaces or areas of poor ventilation.
• DO NOT alter or modify the product in any way.
• DO NOT touch any moving part.
• DO NOT allow water or other liquids to enter the inside of the motor housing or battery compartment.
PowerCap
®
Active
™
: The visor is of lightweight construction and does not provide a high degree of eye protection. In situations where there is any risk to the eyes from projectiles
(for example when strimming) approved type Safety Spectacles must also be worn in the normal way “within Powercap
®
Active
™
”, i.e. Behind the visor. The Powercap
®
Active
™
airow
will help to prevent “fogging” of both the Spectacles and the Visor.
PowerCap
®
Active
™
IP : The visor is manufactured of Polycarbonate and has been tested according to EN166, the standard for Personal eye-protection.
As required by European Health and Safety requirements, the user is advised that when in contact with the wearers skin, the unit may cause allergic reactions to susceptible
individuals. If this is the case the wearer should leave the hazard area, remove the unit and seek doctor’s advice.
WARRANTY:
JSP Ltd warrants to its customers of PowerCap
®
Active
™
that the device will be free from defects in materials and mechanical or electrical defects for a period of 24 months from
date of purchase in accordance with EU Directive 1999/44/EEC.
This warranty is subject to: • PowerCap
®
Active
™
being used solely for the purpose for which it is intended. • PowerCap
®
Active
™
not being subject to misuse, damage, modication or
repair. • The user must register the product to enact this guarantee.
To register the product, visit www.jspwarranty.com
JSP Ltd will replace defective parts as required at no charge. JSP Ltd’s liability will not exceed the value of the original sales receipt for the device. In the event of valid claims under
this warranty JSP Ltd will not be liable for loss of use of any of its products or for any incidental, indirect or consequential cost, expenses or damages incurred or claimed by the
purchaser or any other user. No other terms are implied by this warranty but a purchaser’s statutory rights are not affected. To make a claim under this warranty, please contact the
retailer from which the PowerCap
®
Active
™
was purchased.
MARKINGS:
Battery packs should be disposed of under local disposal regulations.
Batteries should not be disposed of in general waste bins.
BATTERY INFORMATION:
PowerBox™1
MODEL No. PCA-02
Battery Type: Li-ion
Capacity: 4000mAh, 3.7V, 14.8Wh
Battery Designation: 1LXP10/34/50-2
Input: Micro USB 5VDC, 1.0A
Output: 4.2VDC, 3.4A
/
Manufacturers Trademark.
Regulation 2016/425 on personal protective equipment, as
amended to apply in GB.
Indicates that product manufacture meets international performance
and quality management standards.
Conformity to Regulation (EU) 2016/425.
Dispose of in accordance with local legislation. Requires twin lters.
Some components can be recycled. Date of manufacture.
Storage temperature and humidity ranges. Use by date.
See instructions for use. If the instructions for use recommendations are not adhered to, the protection afforded by the device may be
severely impaired.
EN12941:----
European standard for powered ltering respiratory devices
and its year of publication.
A#:---- Amendment to EN12941 and its year of publication.
TH1 Indicates a 90% efciency with an APF 10. P SL R A reusable solid and liquid particulate aerosol lter.
EN812: ---- The European Standard number for Industrial Bump Caps and its year of publication.
53-63 cm The size range of the helmet, head circumference.
EN166: ---- European standard for protective eyewear and its year of publication.
1 Optical quality (high). 3 Liquid Droplets. B Protection against medium energy impact against high speed particles.
Changing the Faceseal Skirt:
Peel the skirt away from the Velcro
®
around the periphery of the visor.
To attach the new skirt to the cap, reverse the above process, starting
with, and working outwards from the centre of the Visor and the Skirt.
5