INSTALLATION AND OPERATING INSTRUCTIONS | WWW.JUICE-PRO.COM.AU 3
B. Assembly Instructions:
Important: Prior to Assembling the Juicer please check this point:
At the base of the bowl there is a rubber stopper. When in place
the stopper ensures all of the juice only exits via the juice outlet.
Before juicing always ensure that the rubber stopper is firmly in
place. (See Fig 2).
1. Assemble the bowl on the base
(See Fig 3).
A. Make sure the bowl is sitting
securely on the base.
2. The strainer supplied is a fine strainer and will reduce the
amount of pulp in your juice.
A. Insert the strainer into the spinning brush.
B. Align the dot on the strainer
with the dot on the bowl and
insert strainer + spinning
brush into the bowl. When the
dots are correctly aligned the
strainer + spinning brush will
lock in place. (See Fig 4).
3. Insert the squeezing screw
into the strainer and turn
until it drops into position.
(See Fig 5).
Fig 2
Rubber stopper
Fig 3
A
Bowl
Fig 5
Squeezing
screw
Fig 4
Dot on
strainer
Strainer
Spinning
brush
Dot on the
bowl
To Next Page
Loading...