12
Mounting position suggested
The wireless keypad should be installed outside of the
property (Pull to Open) and on the same side of the driveway
where the control box is installed. The distance between the
keypad and control box should notexceed 5 meters.
If the keypad is installed on the opposite side of the driveway,
the keypad operation may be interfered by the electromagnetic
waves from a passing vehicle. Refer to the below picture.
Maintenance
● Remove the batteries and store in a cool dry
place away from direct sunlight and
inaccessible to children.
● Clean the keypad with a dry soft cloth. Don't rinse.
Reset the keypad
Step 1. Remove the cover locking bolt and slide out the keypad.
Step 2. Gently hold the reset button located near the interlock
pin using a pin or a similar tool until all the lights on the
keypad lights up, indicating the reset is done.
Step 3. After you resetting the keypad, the factory default the
programming protection is 0000. The channel 1 entry
passcode is 1111 and the channel 2 entry passcode is
2222. Please modify these passcode by reference the
manual, if needed.
To Next Page
Loading...