11
If you want to tutn on the backlight, please repeate the
above operation.
● Passcode Testing
Follow the below steps to find out which channel a passcode
is using.
Step 1. Enter programming protection passcode 8888 . Keypad
will sound a long beep and its blue backlight lights up.
Step 2. Enter 86 . The keypad will sound a short beep.
● Battery Life Checking
Step 1. Enter programming protection passcode 8888 .
Keypad will sound a long beep and its blue backlight
lights up.
Step 3. Enter the 4 digits entry passcode and . If the keypad
sound one beep, mean channel 1. Two beeps
means channel 2.
Step 2. Enter 89 . A long beep means the batteries have a
serviceable life, while a short beep accompanied by a
lit red light means the batteries needs changing.
Keypad Deactivation
Your keypad will sound an alarm 3 times, light the red light,
and remain deactivated for 2 minutes after 3 consecutive
wrong passcode attempts. As this happens, all buttons stay
deactivated. Wait till a short beep is sounded and the red light
dims to normally use the keypad.
To Next Page
Loading...