20
EN
Fitting the brush head
1. Place the brush head turned 90° to the right in relation to the power
switch on the toothbrush.
2. Push the brush head on the shaft (3).
3. Turn the brush head 90° to the left, so that the bristles are facing in the
same direction as the power switch Check that the brush head is rmly
in place (4).
Use
1. Put the required amount of toothpaste on the toothbrush.
2. Put the brush head in your mouth and rub the brush against your front
teeth to press the toothpaste in between the bristles.
3. Press the power switch to start the toothbrush and start brushing at the
back of your mouth.
4. Brush with smooth, slow movements over all the sides of the your teeth,
between your gums and between your teeth. 2–3 minutes of brushing is
usually enough.
5. After brushing your teeth, rinse the brush head under running water and
shake dry.
NOTE: Do not start the toothbrush before putting it in your mouth and switch it
o before taking it out to prevent splashing.
Timer
Normal, careful tooth brushing takes 2–3 minutes. The appliance has a timer.
After 2 minutes the brush head stops for a moment, and then continues to rotate.
To Previous Page
Loading...