19
EN
USE
Charging the battery
1. Plug the plug in a power point.
2. Put the toothbrush on the charger unit. The charge indicator on the
toothbrush goes red.
3. It takes at least 16 hours to become fully charged. The charge indicator
goes green when the battery is fully charged.
4. When the battery is fully charged you can unplug the plug from the
power point, but the battery will not be overcharged if leave the charger
connected to the mains.
5. Charge the battery when the speed drops signicantly, or the brush head
completely stops and the charger ashes red.
NOTE:
• The toothbrush must be switched o during the charging.
• The battery is only partially charged on delivery. Charge the battery before
using it for the rst time.
• Charge the battery when it is discharged, or if the appliance has not be used
for more than 90 days.
• The charger gets warm during the charging. This is quite normal.
• The battery must only be charged with the charger recommended by the
manufacturer.
• The battery life depends on usage and charging cycles. Replace the battery is
there is a signicant reduction in the battery life.
Removing the brush head
1. Turn the brush head 90° to the right (1).
2. Pull o the brush head (2).
To Next Page
Loading...