Jula Meec Tools Multi Series - Non-Intended Use

EN
35
in the paint can. The table below indicates
recommended times for dierent paints.
FIG. 2
Type of paint Time in
seconds
Plastic and latex paints 24–28
Water-based paints 20–25
Undercoats 24–28
Clear varnish 20–25
Oil paint 18–22
Enamel paint 18–22
Aluminium paints 22–25
Underseal for vehicles 25–35
Wood primer 28–35
Wood preservatives and varnishes do not need
thinning.
If emptying the beaker takes longer than the
recommended time, the product needs to be
thinned even more Mix in a small amount of
a suitable thinner and carry out the viscosity
test until the right viscosity is achieved. Some
products can contain particles and lumps. Such
products must be strained before pouring them
into the paint container.
BATTERY
Connect the battery (battery and charger sold
separately in Jula’s department store or www.jula.
com). Only batteries and chargers in the Meec
Multi Series must be used with this product.
Charging the battery
Make sure to do the charging in a suitable
place and to use the right charger. Never
connect an unknown charger or charging cable
or battery that you suspect may be damaged.
5. Battery holder
6. Accessory
FIG. 1
INTENDED USE
The spray gun is only intended for spraying non
combustible paint and enamel that are not
harmful to health.
NON-INTENDED USE
The spray gun must not be used to spray
ammable liquids. Do not use for food,
medicine or other purposes than those
specied in the instructions.
USE
PREPARATION
Do not use textured paints for walls or coverings.
This will block the nozzle. For optimum results it
is important to prepare the surface before using
the spray gun. The paint should also be thinned
to the right viscosity. Make sure the surface to be
painted is free from dust, dirt and grease. Cover
surfaces not to be treated with high quality
masking tape. The paint or uid to be sprayed
must be thoroughly mixed and must not contain
lumps or other particles. The spray gun can be
used for many dierent products. Always read
the recommendations of the manufacturer
when choosing the paint.
THINNING
Most paint is supplied ready for application
by coating and therefore needs to be
thinned before it can be sprayed. Follow the
instructions of the manufacturer for thinning
the paint before spraying. The viscosity beaker
can be used to nd the right viscosity for the
paint. Fill the beaker with paint up to the edge.
Time how long it takes to empty the beaker