To Next PageTo Next Page
Need help?Do you have a question about the Julabo ED-5A/B and is the answer not in the manual?
General| Heating Capacity | 1000 W |
|---|---|
| Display | LCD |
| Bath Volume | 5 L |
| Communication Interface | RS-232 |
| Display resolution | 0.1 °C |
| Power Supply | 230 V, 50/60 Hz |
| Control Type | PID controller |
| Pump Pressure | 0.35 bar |
Details JULABO's adherence to ISO 9001:2008 for temperature control devices.
Guides on unpacking the circulator and checking for transport damage.
Defines the intended application of JULABO circulators for temperature control in bath tanks.
Details the circulator's operation via keypad, microprocessor technology, and PID control.
Emphasizes the operator's role in ensuring safe installation, operation, and maintenance.
Provides guidelines on physical care, ambient conditions, and avoiding interference.
Specifies qualified personnel for operation and safe bath fluid usage.
Instructs on environmentally friendly disposal of electrical equipment according to WEEE directives.
States compliance with European directives and outlines the manufacturer's warranty terms.
Lists detailed technical data, operating ranges, and dimensions for various circulator models.
Defines signal words (Warning, Caution, Notice) and their meanings for hazard communication.
Clarifies the meaning of 'Note!' and 'Important!' for user guidance and tips.
Provides essential safety advice for connecting, operating, and maintaining the circulator.
Guides on placing the circulator correctly in relation to the bath tank and optional covers.
Advises on suitable and unsuitable bath fluids, with cautions against flammable or corrosive liquids.
Details procedures for filling the bath tank and safely draining the bath fluid.
Explains how to modify the pump flow rate for user-specific requirements.
Describes how to connect a cooling coil for applications requiring temperatures below ambient.
Specifies correct procedures for connecting the unit to the power supply, emphasizing safety.
Outlines the steps for powering the unit on, its self-test, and turning it off.
Explains how to configure the AUTOSTART function for automatic or manual unit startup.
Details the process for adjusting the setpoint temperature using the unit's controls.
Covers excess temperature and low liquid level protection systems and their checks.
Provides instructions for cleaning the circulator's exterior and interior bath tank.
Advises on contacting service stations and preparing units for repair or return.
