Need help?Do you have a question about the Julabo SL-12 and is the answer not in the manual?
General| Brand | Julabo |
|---|---|
| Model | SL-12 |
| Category | Controller |
| Language | English |
Instructions for checking the unit for transport damage.
Overview of the circulator's components and technology.
Guidance on proper disposal of the unit and its components.
Statement of compliance with European directives.
Terms and conditions for product warranty coverage.
Detailed technical data and parameters of the circulators.
Clarifies the meaning of warning symbols and signal words.
Explains symbols for notes and important tips.
Specific safety precautions for installation, operation, and maintenance.
Guidelines for correctly placing and setting up the unit.
Recommendations and warnings regarding suitable bath fluids.
How to connect for external temperature control.
Specifics on recommended tubing for connections.
Procedures for adding and removing bath fluid.
Setup for using external cooling water.
Correct procedure for connecting the unit to power.
How to power up the unit and choose the display language.
Basic operation to start and stop the circulator.
Operation of the low fluid level detection system.
How to initiate a stored temperature program.
Managing and creating temperature programs.
Adjusting the pump speed and capacity.
Setting up communication with a PC via RS232/RS485.
Options for inputting setpoints.
Configuring automatic startup after power loss.
Setting pump behavior when the unit is off.
Defining the control variable for heating/cooling.
Adjusting the internal real-time clock.
Selecting the display language.
Choosing between Celsius and Fahrenheit display.
Setting program mode to time or gradient.
Restoring factory default settings.
Switching between internal and external sensor control.
Automatic adjustment of control parameters.
Setting the internal control dynamics for temperature response.
Adjusting external control response speed.
Manual tuning of PID controller parameters.
Selecting the sensor for ATC calibration.
Activating or deactivating ATC calibration results.
Choosing the number of calibration points.
Step-by-step guide for a 3-point internal calibration.
Defining setpoint and heating/cooling limits.
Setting internal bath limits and band limitations.
Settings for the SV-Out, Backflow, C-Pulse, Refill functions.
Defining output values and scales for channels.
Setting up external voltage/current signals and flow meters.
Configuring the external shutdown input.
Setting alarm signal behavior and type.
Pinout for external temperature sensor connection.
Pinout for computer communication.
Initial configuration steps for remote operation.
How the unit communicates with master systems.
Reference for remote control command syntax and function.
Codes indicating the unit's operating state.
List of error codes and their meanings.
To Next Page
