4. GENERAL RULES AND INSTRUCTIONS FOR USE
4.1 Mounting and dismounting must be done in accordance with the installation instructions or by agreement with the
manufacturer. JUMBO HOBBY Scaffolding must be installed in level. Scaffold towers mustl be assembled or dismant-
led only by persons with the necessary knowledge of the structure and use. Scaffold towers can be assembled by one
person, but it is recommended to be 2 persons, as this is faster and more secure.
4.2 Before assembly, all components should be checked. Only original, undamaged JUMBO components should be used.
4.3 The castors should be mounted and fastened inside the frame´s vertical tubes. The weight must always be evenly
distributed over all 4 castors.
4.4 The frames must be secured with self-locking clips. The curved part of the clips should pint outwards and
downwards, it automatically locks.
4.5 JUMBO HOBBY Scaffolds should always be assembled on a solid and sustainable base. When moving the scaffold
push only in the longitudinal direction. During movement the inclination must never exceed 2°, and move only at
walking speed. Avoid jolts and impacts.
4.6 When moving the JUMBO HOBBY scaffold make sure no persons og loose items are on the scaffold.
4.7 After moving the brakes must be engaged at once. To prevent accidental runaway ensure that all castors are
braked before entering or leaving the scaffolds. Before the scaffold is used, ensure that it is structured according to
instructions.
4.8 Beware of overhead obstructions. The scaffold must always be min. 3 m from live electrical wires!
4.9 Lifting devices or hoists must not be placed on or attached to JUMBO HOBBY Scaffolds.
4.10 Only climb on the scaffold from the inside. Access hatches must always be arranged offset relative to each other
and must always be kept closed. Ascent and descent of the platform must only take place by the designated access
routes.
4.11 Persons working on the JUMBO HOBBY Scaffold must not lean against or over the guardrail.
4.12 The scaffold should not be used to support building components.
4.13 Do not use extra ladders, boxes, ecc. to increase the range.
4.14 It is not allowed to jump onto platforms or throw anything down on them.
4.15 Corrosive liquids and jolts are not allowed.
4.16 Do not expose the scaffold to long stays at under -20 ° C or over +70° C.
4.17 Do not use the scaffolding outdoors or in open buildings, if the wind speed exceeds 12.5 m / sec. it must be placed
in a protected location so it does not tip over, or possibly dismantled. The same must be done at the end of workday.
4.18 Do not attach advertising signs or similar on the scaffold, it might increase the windload
4.19 Always show a good example and make it a good habit to use personal protective equipment (helmet, gloves, safety
footwear and lifelines)
4.20 The assembly instructions must always be at the scaffold. .
4.21 If the scaffold is handed over to a third person, the assembly instructions must always follow.
To Next Page
Loading...