Jumbuck JEH425 - Operation & Cleaning; Operating the Heater; Cleaning the Heater

7
6
To Operate
NOTE: REMOTE CONTROL WILL ONLY OPERATE FROM
STANDBY MODE.
1. Plug into 240V AC wall socket and turn on.
2. Press the ‘ON/OFF’ switch on the back of the heater
head to on ‘
- ’. Blue light will flash indicating it is in
standby mode.
3. Press the ‘ON’ button on front panel or remote control
and the heater will start. The blue light is now on.
4. To turn heater off and leave on standby mode press
‘OFF’ button (use either control panel OR remote
control). Heater is now off and in standby mode. Blue
light flashes.
5. To turn heater off completely press ‘ON/OFF’ switch on
the back of the heater head to off ‘O’.
6. Turn off at wall socket and unplug.
Cleaning
Always ensure that the floor/wall heater has been left for
one (1) hour to cool before cleaning.
1. Turn off and disconnect from mains power, allow to
cool.
2. Wipe unit over with a damp clean soft lint free
cloth.
3. For stubborn marks you can use a mild dish washing
solution on a damp clean soft lint free cloth.
NEVER allow water or a mild dish washing solution to enter
or drip onto the floor/wall heater.
NEVER use solvents, e.g. Petrol, Toluene, Methylated Spirits
etc. to clean the heater, as these will damage the surface
finish and may cause a fire when unit is next used.
Operation & Cleaning
SENSOR
ON OFF
OFF
ON
Off
On
Side View Front View
Remote