4 Commissioning the instrument
13
Currently remaining running time
e.g. for cooling/heating operation etc.
999h ... 2h,
120min ... 2min,
120s ... 0s,
With setting
,
t. i cannot be edited
Service interval
The time period after which the equipment unit has to be serviced is set
here. The active relay time is taken into account.
0 ... 999h ... 9.9t h
Current service counter for equipment unit connected
This shows how much time has elapsed since the last service.
On reaching the interval , an alarm message is generated.
If the counter is reset after a service, the alarm message disappears.
0 ... 999h ... 9.9t h
Display of the total operating hours
Active time of relay for maintenance of heating or cooling units.
0 ... 999h ... 9.9t h
Temperature display during defrosting
Freeze temperature value during defrosting: 0
Update temperature value continuously: 1
0, 1
Parameter Meaning
Value range
from...factory-set...to
To Next Page
