Jumpking Oval POD - Step 5: Fitting the Enclosure Tubes; Assembling Enclosure Poles

12
STEP 5 : FITTING THE ENCLOSURE TUBES
Top enclosure tube
You will need the following parts to complete step 5:
Bottom enclosure tube
8 x Top enclosure tubes - Part M
8 x Bottom enclosure tubes - Part L
8 x Self tapping screws and washers
- Part P
Self tapping screw and washer
You will also need a cross-head screwdriver (not
supplied).
Cross-headscrewdriver
Slot the thin end of one of the bottom enclosure
tubes into the open end of one of the top
enclosuretubes.
Align the hole in the bottom enclosure tube with
the slot in the top enclosure tube.
Screw one of the self tapping screws through the
slot in the top enclosure tube and into the hole in
the bottom enclosure tube using the cross-head
screwdriver.