Jun Shade JSR-4300 User Manual

0
N O
1 2 3
Model . JSR - 4300
RF REMOTE CONTROLLER
1
3V
Operationg Voltage
SPECIFICATION
Curtain Motor
RF Receiver
HOW TO ERASE SET-UP CHANNEL
HOW TO SET-UP
Operationg Distance
Within 1km
Operationg Frequency
447.775 MHz or
433.92 MHz
Radio Wave type
Wireless Standard
F10
Communication System
Wireless device for wireless
minimal output
1 Way RF
1 2 3
0
N O
Curtain motor : Put 1st terminal of DIP switch to "ON". The LED of the curtain motor blinks when you do this.
Receiver : If you release PROG button after pressing it for 2 seconds, the Red LED blinks.
1. Set installed curtain motor or receiver to Set-Up mode
2.
Select desired any channel by button. The number of the desired channel is indicated by LED Light comes ‘ON’
3. Press PROG Button on the back of Controller for 2 seconds.
1. Turn NO.1 dip S/W to ‘on’, right side, LED in motor blinks.
4. If Remote Controller complete Set-Up correctly, the buzzer sound once.
Curtain Motor : Buzzer sounds once
RF Receiver : Red LED Light comes ‘ON’
5.
Turn the 1st terminal of the DIP switch to "OFF". Then, if the LED of the curtain motor lights ‘ON’.
The Remote controller Set-Up is finished.
6.
Set the rest of the channels in the same way.
RF Remote Controller retains the last selected channel.
Each Set-Up channel is memorized for collective control without additional Set-Up Procedure.
2. After selecting the applied channel, press PROG button for 2 seconds. If erasing completes correctly,
the buzzer sounds two times from motor and controller.
1. Red LED Light comes off when you press PROG button for 2 seconds and take off.
2. Press PROG button for 2 seconds after selecting the applied channel.
If erasing completes correctly, the buzzer sounds two times from Romote controller & Red LED L ight comes off.
( Caution : If there are remained Set-Up channel in Remote Controller, Red LED Light keeps ‘ON’)

Jun Shade JSR-4300 Specifications

General

Brand	Jun Shade
Model	JSR-4300
Category	Remote Control
Language	English

Summary

AUTOLINE RF REMOTE CONTROLLER SPECIFICATIONS

General Operating Parameters

Details on operating voltage, distance, frequency, radio wave type, wireless standard, and communication system.

HOW TO SET-UP

Curtain Motor and RF Receiver Setup Procedure

Step-by-step guide for setting up curtain motors and RF receivers with the remote controller.

HOW TO ERASE SET-UP CHANNEL

Curtain Motor Channel Erasure

Instructions for erasing setup channels from the curtain motor.

RF Receiver Channel Erasure

Instructions for erasing setup channels from the RF receiver.

HOW TO COPY REMOTE CONTROLLER

Master to Slave Controller Copying

Procedure for copying settings from a master remote controller to another.

HOW TO SET-UP LIMIT

Curtain Motor Limit Setting

Steps to automatically set the upper and lower limits for the curtain motor.

OTHER FUNCTIONS

Mute/Sound Functionality

How to toggle the mute or sound feedback function on the remote controller.

Tilting Operation

Explanation of how to operate the tilting function by holding OPEN or CLOSE buttons.

Percentage Unit Control

Guide for controlling curtains or blinds using percentage-based unit commands.

HOW TO REPLACE BATTERIES

Battery Replacement Procedure

Step-by-step instructions for replacing the lithium battery in the remote controller.