37
en
II
)
Additional (optional) means of an-
chorage (thin double-sided adhesive
lm) acc. to vfdb 14/ 01 (Q) and EN
14604:2005/AC:2008
Caution:
The additional application of this op-
tional means of anchorage establish-
es an extremely strong and therefore
durable connection of the device to
the anchorage means (magnetic holder
with self-adhesive coating on reverse
side) as described in I) and thus to the
installation surface. If you apply this ad-
ditional anchorage means it is no longer
possible to release the device by pulling
it off the self-adhesive magnet holder
(I) vertically. This provides increased
removal protection (theft protection).
Only use this anchorage means in ad-
Remove the information sticker, as
shown in Fig. 2, and then the protec-
tive sheet from the adhesive applied
on the magnets. Press the magnetic
holder rmly for about 10 seconds on-
to the location chosen for installation.
Afterwards, the device can be mount-
ed onto the magnetic holder (Fig. 1b).
Should it be necessary, the device can
then be pulled off the magnet holder
vertically.
The adhesive bond attains its final
strength after approx. 72 hours.
To Next Page
Loading...
Need help?
General
