4544
What is shown on the LCD display switches to the month setting, e.g. [M 01].
You again perform the setting via the T2 button. The month you want must
then again be confirmed by briefly pressing the T1 button.
Perform the following settings using the procedure described above:
– Set the date - what is shown on the LCD display switches to [D 01]
– Set the hour - what is shown on the LCD display switches to [00: ]
– Set the minute - what is shown on the LCD display switches to [ :00]
In order to get the seconds displayed correctly, please ensure that you always
set the watch to the next full minute and confirm the time at the 60th
second.
After you have set the minute and confirmed this by pressing button T1, the
hands of your radio-controlled watch then move to the time that you set.
The date is shown on the LCD display. A 2
nd
time can be set as normal.
If necessary, the programmed time can be corrected by holding down button
T2 for longer than 3 seconds.
Your watch is now in quartz mode and will not make any automatic
attempts to pick up a time signal. You can make a manual transmitter call,
however, at any time.
If you make a transmitter call while in quartz mode, then in addition to the
current seconds an [M] is displayed on the left. This indicates that the trans-
mitter call is being launched in quartz mode.
A successful transmitter call overwrites the manually set time and after-
wards your watch works as a radio-controlled watch.
8. General information
External influences can affect the watch’s waterproof qualities, which may
let in moisture. We therefore recommend that you have your watch regular-
ly inspected by your Junghans specialist. Other servicing tasks or wrist strap
repairs should also be done by your Junghans specialist. Your watch is fitted
with a quality wrist strap that has undergone multiple inspections in our
factory. If, however, you decide to change the strap, please fit a new one of
the same quality, preferably an original Junghans wrist strap. Watch and
wrist strap can be cleaned with a dry or slightly moistened cloth.
NB: Do not use che mical cleaners (e.g. benzine or paint thinners). These may
harm the surface.
To Next Page
Loading...
