Mesa Barcode Scanner Owner’s Manual 15
Pick List Mode – Enable this mode if barcodes
are close together. The scanner only decodes
barcodes aligned directly under the center
of the aiming crosshairs. Disable this mode
if only one barcode is viewable. The aiming
crosshairs do not have to line up directly on
the barcode in order for the scanner to read it.
Just aim the scanner in the general area where
the barcode is located. This can be helpful in
situationswhereitmightbedifculttoprecisely
aim the scanner, such as in locations with
bright sunlight. Read the Help on this topic for
more information.
Consecutive Read Level – Select how many
successful consecutive reads the barcode must
get before being decoded. Read the Help on
this topic for more information.
To Next Page
Loading...
