Juniper Mesa - Page 25

Mesa Barcode Scanner Owner’s Manual 25
3 – I need to set up several Mesas the same way.
DoIneedtocongureallofthemindividually?
Reason/Solution:Youdon’tneedtocongure
them individually. Set up one Mesa the way you
wantalltheMesastobecongured.Copythe
“LastUser.cfg”lefromthisMesalocatedat
“\Program Files\Barcode Connector” to the other
Mesas. (You can use a thumb drive to transfer the
information from one Mesa to another or transfer
it to a PC and download it from there to the
other Mesas using synchronization software. See
the Mesa manual for details). If you want to be
able to restore to this point, after you set up the
rstMesa,gototheProles tab, and save these
settings as Prole 1.Copythe“Prole1.cfg”le
located at “\Program Files\Barcode Connector”
to the other Mesas. Now all the Mesas can load
from Prole 1 to get back to this restore point.
4 – When I read a barcode, the data returned is
not correct.
Reason/Solution:Ensurethatthecongurations
are set up correctly so you are given the
information you need. For example, to read a
Code 32 barcode, on the 1D Code Type tab,
ensure that Code 39 is selected. Select Options,
and on the Code 39 tab ensure that Convert
Code 39 to Code 32 is selected.