EasyManuals Logo

Juniper MX480 Manual

Juniper MX480
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Removing Components from the MX480 Chassis Before Installing It Without a Lift
If you cannot use a mechanical lift to install the router (the preferred method), you
can install it manually. To make the router light enough to install manually, you first
remove most components from the chassis. The procedures for removing components
from the chassis are for initial installation only, and assume that you have not
connected power cables to the router. The following procedures describe how to
remove components from the chassis, first from the rear and then from the front:
1. Removing the Power Supplies Before Installing the MX480 Router Without a
Lift on page 1
2. Removing the Fan Tray Before Installing the MX480 Router Without a
Lift on page 2
3. Removing the SCBs Before Installing the MX480 Router Without a Lift on page 3
4. Removing the DPCs Before Installing the MX480 Router Without a Lift on page 4
5. Removing the FPCs Before Installing the MX480 Router Without a Lift on page 5
Removing the Power Supplies Before Installing the MX480 Router Without a Lift
Remove the leftmost power supply first and then work your way to the right. To
remove the AC or DC power supplies for each power supply (see Figure 1):
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the strap to one of the ESD points on the chassis.
2. On an AC-powered router, switch the AC input switch on each power supply to
the off (O) position. On a DC-powered router, Move the DC circuit breaker on
each DC power supply to the off (O) position.
We recommend this even though the power supplies are not connected to power
sources.
3. Loosen the captive screws on the bottom edge of the power supply faceplate.
4. Pull the power supply straight out of the chassis.
Removing Components from the MX480 Chassis Before Installing It Without a Lift 1

Other manuals for Juniper MX480

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Juniper MX480 and is the answer not in the manual?

Juniper MX480 Specifications

General IconGeneral
CoolingFront-to-back airflow
Operating SystemJunos OS
Form FactorModular
Routing EngineRE-S-1800x4
Maximum Capacity7.68 Tbps
ThroughputUp to 3.84 Tbps per slot
Power SupplyRedundant AC or DC power supplies
Chassis Slots6 slots
Operating Temperature0°C to 40°C (32°F to 104°F)
Supported ProtocolsBGP, OSPF, IS-IS, MPLS, IPv4, IPv6
RedundancyRedundant Routing Engines, power supplies

Related product manuals