EasyManuals Logo

JUNO J6SLC RGBW MW User Manual

JUNO J6SLC RGBW MW
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
INSTALLATION INSTRUCTIONS
Juno Smart LED RGBW Speaker LED Trim Kit
912-00386-001 REV F
DATE 10/2023
PAGE | 11
UPDATE SPEAKER LIGHT FIRMWARE:
For this section, either watch the videos by scanning the QR Codes below or read the step-by-step
instructions in this guide.
1. Download the SmartThings app (made by Samsung Electronics Co., Ltd.) on your smart device.
Make sure your smart device has the most recent version of the app downloaded.
Note: A Samsung SmartThings account must be created within the app to continue with the smart fixture set-up process.
2. If the fixture was not set up in SmartThings, all fixtures must be factory reset before the firmware
update can initiate. To factory reset, turn the light off and on at the LIGHT SWITCH five times slowly
(five seconds between each on/off). The light will then blink three times and return to 3000K light
output to show factory reset complete. Then, the user can connect to SmartThings in the following
steps.
3. Connect the fixture to the SmartThings app by selecting the “ ” sign on the top right corner of the
interface and select “add device”. Use one of the methods below to connect the fixture. (Figure 8)
Note: Only one fixture can be set up at a time. If multiple fixtures need to be set up, the setup process will need to be repeated.
Note: The device will not be able to connect to SmartThings if the Smart Fixture has been “ON” for more than 5
minutes. The user must turn the light OFF at the wall switch, wait 10 seconds, and then turn the light ON, again, if the
Smart Fixtures are no longer connecting to SmartThings. This process is often required to set up multiple units (4 or
more) at one time.
A. Scan a QR code
i. Use your smart device’s camera to scan SmartThings QR code on side of
device (Figure 7)
Note: Be sure to not scan the Installation Instructions QR code also present on device’s trim.
Figure 7
One Lithonia Way · Conyers, GA 30012 · Phone 1-(800)705-7378
Visit us at www.acuitybrands.com/juno-recessed
© 2023 Acuity Brands Lighting, Inc.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the JUNO J6SLC RGBW MW and is the answer not in the manual?

JUNO J6SLC RGBW MW Specifications

General IconGeneral
BrandJUNO
ModelJ6SLC RGBW MW
CategorySpeakers
LanguageEnglish