The appliance returns to the programme
selection.
The washing and drying results are not satisfactory
Problem Possible cause and solution
Poor washing results. • Refer to "Daily use", "Hints and tips" and the basket
loading leaflet.
• Use more intensive washing programme.
• Activate the Extra power option to improve the washing
results of a selected programme.
• Clean spray arm jets and filter. Refer to "Care and
Cleaning".
Poor drying results. • Tableware was left for too long inside the closed appli‐
ance. Activate AirDry to set the automatic opening of the
door and to improve the drying performance.
• There is no rinse aid or the dosage of rinse aid is not
sufficient. Fill the rinse aid dispenser or set the level of
rinse aid to a higher level.
• The quality of the rinse aid can be the cause.
• We recommend to use rinse aid always, even in combi‐
nation with multi-tablets.
• Plastic items may need to be towel dried.
• The programme does not have the drying phase. Refer
to "Programmes overview".
There are whitish streaks or
bluish layers on glasses and
dishes.
• The released quantity of rinse aid is too high. Adjust the
rinse aid level to a lower level.
• The quantity of detergent is too high.
There are stains and dry water
drops on glasses and dishes.
• The released quantity of rinse aid is not sufficient. Adjust
the rinse aid level to a higher level.
• The quality of the rinse aid can be the cause.
The interior of the appliance is
wet.
• This is not a defect of the appliance. Humid air conden‐
sates on the appliance walls.
Unusual foam during washing. • Use the detergent designed specifically for dishwashers.
• There is a leak in the rinse aid dispenser. Contact an
Authorised Service Centre.
Traces of rust on cutlery. • There is too much salt in the water used for washing.
Refer to "The water softener".
• Silver and stainless steel cutlery were placed together.
Do not put silver and stainless steel items close togeth‐
er.
26
To Next Page
Loading...
