Junso JS-6618 - Functional Modes; Alarm, Timer, and Thermometer; Chronograph Operation; Maintenance

15
EN
Allarm setting
Press button D to select TIME/ALARM mode, press and hold the button B for 2 seconds to enter the
settings mode. Time settings can be done by pressing button B to select digits and button A to advance
digits. Alarm can also be armed or disarmed by pressing button C at TIME/ALARM mode.
Chronograph operation
Press button D for enter to operating mode. Press button C to start chronograph, press the same button to
stop. Press button A to reset. You can also read the lap time, press button C to start chronograph, press
button A to read the 1st lap time, press the same button again to read next lap time. Press button C to
stop counting. Press button C, it will display the average (AVE) lap time of the laps traversed. Press
button B to recall 1st lap data during the recall mode. Press button B again to recall the 2nd lap data,
again to recall next lap data. Press button D to return to operating mode.
Timer function
Press button D to enter THERMOMETER/TIMER mode. Press and
hold button B for 2 seconds to go into the setting TR mode. Press
button A to set desired hour, minutes and seconds for countdown.
Press button C to confirm. Press button C to start countdown. You
can anytime stop the countdown by pressing button C.
Thermometer
Press button D to enter THERMOMETER/TIMER mode. Press button B to display Celsius or
Fahrenheit temperature. When temperature is lower than floor level, the display will be LO, when
temperature is higher than upper limit, display will be HI.
Maintenance:
The following suggestions will help to extend the timer life:
 Keep the appliance in dry.
 Use and store the appliance under normal temperature.
 Do not expose the appliance to shocks, this would damage the circuit board and make the timer
malfunction.
 Do not clean the appliance with abrasive or corrosive products.
 Only use new batteries of the type indicated in this notice. Replace the old battery with new one in
time.
 Do not touch the appliance´s internal components. This would risk causing damage and the
warranty will be terminated.