Jura IMPRESSA E10 - 22. Problems

20
22. Problems
Problem Cause Remedy
Very loud noise coming from the Foreign body in grinding gear Drawing off pre-ground coffee still possible
grinding gear
Have IMPRESSA E10/20/25 checked by JURA
Service
Too little froth when frothing jet blocked clean frothing jet
frothing milk
frothing jet in wrong position Draw off steam (Chapter 12)
Coffee only drips Grinding degree too fine Coarser grinding gear adjustment
from the coffee spout
Pre-ground coffee too fine Use a coarser pre-ground coffee
High-frequency, electromagnetic interference may influence the display. Drawing off coffee is possible at any time.
If the messages or problems still persist, please contact your local authorized dealer or JURA Elektroapparate AG.