juwel Eccoflow - Page 20

Installaon of the pump JUWEL Eccoflow in the filter system Bioflow Super,
M, L & XL
Maintenance of the pump JUWEL Eccoflow in the filter system Bioflow
Super M, L, XL
The JUWEL Eccoflow pump should be checked with regard to funconality and cleaned at regular intervals (at least once a month).
Please proceed as follows to this end:
Aer that, please reinstall the pump in reverse order in the filter.
Please ensure that the impeller has been properly inserted and the pump adapter has
been firmly connected to the motor prior to the installaon of the new pump.
Please proceed as follows:
1. Disconnect all electrical devices of the aquarium from the power grid.
2. Remove the outlet nozzles and remove the old pump from the filter.
3. Insert the new pump into the separaon wall of the filter and firmly push it into
place.
4. Connect the outlet nozzle to direct the waterflow as desired from the outside to the
outlet opening of the pump. Reinstall the gasket into the round opening of the filter
housing when connecng the outlet. This decreases vibraon transmissions.
Now the pump is ready for operaon and you may reconnect the electrical devices to
the power grid.
Disconnect all electrical devices that are operated in the water from the power grid.1.
Remove the outlets.2.
Remove the pump from the pump retainer of the filter.3.
Disconnect the adapter (A) from the motor by turning it counter-clockwise and remove the impeller from the chamber.4.
Now clean all components thoroughly. Deposits and dirt should in parcular be removed from the pump chamber, the impeller
and pump sha. Otherwise the funconality of the pump will be impaired.
5.
Check the impeller for damage and possible signs of wear of the magnet. You should also ensure that the two rubber bearings
are located on the ends of the pump sha.
6.
4