JUWEL AquaHeat Pro - Installing the heater in the JUWEL filter
system
OPTIONAL:
Amorax
Amorax is a highly efficient filter medium made of natural zeolite. It quickly and
effectively binds ammonium, thereby preventing the formation of ammonia and
promotes the vitality of your fish. Replace the JUWEL Amorax every 3 months.
Carbax
Carbax's excellent absorption properties permanently and quickly bind
discolourations, odours and toxic substances and ensure crystal-clear water. We
recommend replacing JUWEL Carbax every 2 months.
Cirax
Cirax is a biological filter medium which creates the perfect colonisation conditions
for useful bacteria, due to its large, highly porous surface. We recommend changing
JUWEL Cirax every 12 months.
Phorax
JUWEL Phorax is a highly effective filter medium used to break down phosphates in
your aquarium. This effectively reduces the growth of algae and can contribute to
improved plant growth. Change JUWEL Phorax every 2 weeks.
Important:
Always use original JUWEL Aquarium filter media to ensure the optimum
performance of your system.
The JUWEL aquarium heater is supplied with the heater holder (fig. 1) which you
will need for the installation.
Please perform the following steps for all JUWEL Aquarium filter systems: (You may
need to start by removing an installed separation wall holder.)
1. Install the heater holder.
2. Attach the heater to the filter housing on the inside of the filter and/or initially insert
the heater holder into the guide rail of the separation wall.
The heater is properly positioned if the heater holder rests on the upper edge of the
housing and/or the separation wall.
The heater is now operational.
To Next Page
