Page 4 © JVA Technologies www.jva-fence.com
1.4 QUICK TEST OF CONFIGURED UNIT
It is a good idea to test the energizer before connecng the it to a fence.
This will give you condence that the unit is operang as expected and it
also isolates potenal fence issues.
To do this, connect your energizer with a “test fence” as shown.
Power the energizer and then Arm it. The unit should begin pulsing and
not show any alarms. Disarm the energizer and remove the fence cable as
shown.
Arm the energizer once again, aer 3 pulses (unless you congured it oth-
erwise) the unit should go into alarm as the fence will appear to be cut.
Check that any sirens, strobes or relays acvate as expected.
To Next Page
Loading...
Need help?
General
