EN-4
CHARGING THE BATTERY PACK
SUPPLY POWER
1
Connect the charger’s AC power cord to a
wall outlet.
ATTACH BATTERY PACK
2
Align the marks and slide the battery pack
in the direction of the arrow until it locks
in place.
•The CHG. indicator begins blinking to
indicate charging has started.
DETACH BATTERY PACK
3
When the CHG. indicator stops blinking
but stays lit, charging is finished. Slide the
battery pack opposite the direction of the
arrow.
CHG. (charge)
indicator
Marks
To AC outlet
REFRESH indicator
REFRESH switch
REFRESH
The AC power adapter features a REFRESH
function that allows you to fully discharge the
battery pack before recharging. Perform the
REFRESH function after no less than 5 chargings.
To discharge the battery . . .
...... attach the battery pack to the adapter as
shown in the above illustration. Then push
REFRESH. The REFRESH indicator lights
when discharging starts, and goes out when
discharging is complete.
To Next Page
Loading...
Need help?
General
