V-28WT5EIS AV-24WT5EIS
34
Item
Measuring
instrument
Test point Adjustment part Description
Adjustment of
H.CENTER
4.H-CENT.
6. Receive a circle pattern signal.
7. Select 4.H-CENT and set the initial setting value.
8. Adjust H-CENT to make C=D.
9. Press the MENU key and memorize the set value.
Adjustment
of
H.SIZE
5.H-SIZE
10. Receive a circle patteern signal.
11. Select 5.H-SIZE and set the initial setting value.
12. Adjust H-SIZE and make sure that the horizontal screen size
of the picture size is in the bellow table.
13. Press the MENU key and memorize the set value.
※
The numeric of the REGULAR and 14:9 ZOOM modes are
shown the length of the 90% horizontal size position(
L
) as
shown in the figure above.
14. Input a NTSC VIDEO signal (60Hz) from the EXT terminal,
and make sure that the horizontal screen size of the each
ASPECT mode is in the below table.
15. Press the MENU key and memorize the set value.
Adjustment of
EW-PIN
6.EW-PIN
16. Select 6.EW-PIN and set the initial setting value
17. Adjust EW-PIN and make the 2nd.vertical lines at the left and
right edges of the screen straight. Also make sure that the 3rd
vertical lines are straight.
18. Press the MENU key and memorize the set value.
ASPECT
MODE
PANORAMIC 14:9 ZOOM 16:9 ZOOM
16:9 ZOOM
SUB TITLE
FULL REGULAR
PAL=95%
28”
NTSC=94%
L=495mm 92% 92% 92% L=440mm
PAL=95%
H SIZE
24”
NTSC=94%
L=425mm 92% 92% 92% L=380mm
[ SCREEN SIZE ]
CD
L
90%
90%
Straight
To Next Page
Loading...
