JVC CA-MD70 - JOIN Function

– 30 –
English
7 Press SET.
• If you want to cancel the editing, press CANCEL.
8 Press ENTER to finish the editing procedures.
9 Press 0 to eject the MD.
“WRITING” appears while the editing you have made
is being recorded on the MD.
To join the divided tracks again, see the JOIN function.
JOIN Function
This function allows you to join two adjacent tracks into
one track.
• To do the following procedures, use the buttons and
controls on the unit.
• To stop any time during editing process, press MD EDIT.
1 Insert an MD you want to edit into the MD loading
slot.
The MD IN lamp lights.
2 Press MD EDIT.
The MD recorder enters editing mode (with DIVIDE
function selected).
3 Rotate MULTI JOG until “JOIN” is selected.
4 Press SET.
5 Rotate MULTI JOG to select the two adjacent
tracks you want to join.
6 Press SET.
• If you have selected wrong tracks, press CANCEL,
then select the correct tracks by rotating MULTI
JOG.
• If you want to cancel the editing, press CANCEL.
7 Press ENTER to finish the editing procedures.
8 Press 0 to eject the MD.
“WRITING” appears while the editing you have made
is being recorded on the MD.
To divide the joined tracks, see the DIVIDE function.
Ex.: When joining tracks 1 and 2
Continued
EN28-48.CA-MD70[U] 98.11.18, 3:22 PM30