JVC D Series - Set Lock Code

ChannelguardandV-Chipsettingsareprotectedbyafour-digitlockcode.YourTVcomespre-
setwithalockcodeof"0000".Youmaychangethecodetoanyfour-digitnumberyouwish.To
changethelockcode,followthestepsbelow.
PresstheMENUbutton
AV ToSETLOCKCODE
4 _ Tooperate(lockiconI_1 appears)
Press ZERO to access the lock code
The first digit will be highlighted
4 _ To select the number
AW To move to the next digit
o
i i i
ii ii iii i_ i_i ii i iii_
FINIS H
SELECT BY_
OPERATE BY_ EXiT BY l_lii
Continue to follow these directions for all four numbers
AV
4_
To FINISH
To save settings and exit
(your lock code is now set)
Press the EXIT button when finished
When a viewer attempts to watch a blocked channel, this message appears:
THfS PROGRAMMING EXCEEDS I
YOUR RATING LiMiTS. I
PLEASE ENTER LOCK CODE By I
! 0 KEY pAD TO UNLOCK IT:
1
The channel will remain blocked until the correct lock code is entered (see above for information
on setting your lock code).
Notes:
After a power interruption you must reset the lock code.
• Write your lock code number down and keep it hidden from potential viewers.
• If you forget the lock code, a new code may be set using the steps listed above.